User guide

821697: AMP1-16 Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
13
Chapter 2 Audio and Metering
Configuring the Audio Outputs
analog output pairs are available for this purpose. The front panel
Volume, Balance, and solo controls will then affect the stereo
downmix output sound. You can easily configure a stereo downmix in
the AES Output Menu and the Analog Output Menu. Note that the
stereo downmix will also be affected by the trim, speaker assign, and
delay in the
Monitor Mixer Configuration Menu, and also by the
trim, channel output, and mute with headphone settings in the
AES
Output Menu
/Analog Output Menu.
The Monitor Downmix pair is one of the sources listed on the AES
Output Configuration Menu
and the Analog Output
Configuration Menu
. Configure either menu as follows.
1. From the Main Screen, press either the  button or the
 button to display the Configuration Menu.
2. From the Configuration Menu, select either the AES Output
Configuration Menu
or the Analog Output Configuration
Menu
depending on the output type you want to use. In our
example, we’re using the AES Output Configuration Menu.
3. If needed, press the AES Output = Monitor Channels button
and then press the Balance knob to display AES Output =
Selected Sources
.
See Figure 2–3 on page 13. In our example, the AES Output
Configuration Menu
displayed with AES Output = Selected
Sources
so we didn’t need to change that. But it did display
“matching” inputs (5 and 6) and outputs (5 and 6). We’ll modify
this in the next step.
Figure 2–3 Select AES Output = Selected Sources
AES Output Configuration Menu
AES Output Channels 5/6 AES Output Channels 7/8
+0 +0 +0 +0
Level Trim
65 65 87 87
Affected by
Volume Control
Affected by
Solos & Mutes
Output Mute
With Headphone
AES Output =
Selected Sources
No
No
No
No
Yes
SDI In Channels 7/8SDI In Channels 5/6
Channel Output
AES Channel Pair