User guide

821697: AMP1-16 Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
11
Chapter 2 Audio and Metering
Configuring the Audio Outputs
as presets and recalled later. See Chapter 4: Efficiency Enhancements on
page 25.
Figure 2–1 Audio Routing Diagram
Surround Sound
If a studio or other monitoring environment contains a surround sound
system, it may be advantageous to connect the monitored sound from
the AMP1-16 Series monitor to this system. Up to eight pairs (16
channels) of AES outputs or four pairs (eight channels) of analog
outputs are available for this use. The front panel Volume, Balance,
and solo, and mute controls will then optionally affect the surround
sound. You can easily configure this in the
AES Output and the
Analog Output Configuration Menus as described below.
3G SDI Input 1
3G SDI Input 2
3G SDI Output
AES Inputs
Analog Outputs
AES Outputs
Monitor Amplifiers, Speakers, & Headphone Jack
8 De-embedded SDI Pairs
8 AES Pairs
5 Dolby Pairs
8 Monitor Mixer Pairs
Monitor Downmix Pair
Configuration Selection
Recall Preset1
SDI Source2
Monitor Menu3
Screen Menu4 Dolby
Preset Mgmt 5
Analog Out 6
7AES Out
8
Dolby Configuration Menu
Decoder Src1
Pro16 Mode2
Dolby E Pgm3
4
5
Bitstream Det 6
7
8
Monitor Mixer Config Menu
Sel Channel1
Channel Trim2
Spkr Assign3
Mute Spkrs4
Audio Delay 5
Channel Src 6
7
Phase LED 8
AES Output Menu
AES Output1
Affect S/M2
Level Trim3
AES Ch Pair4
5
6Affect Vol
7Chan Output
8Mute w/ HP
Analog Output Menu
Analog Out1
Affect S/M2
Level Trim3
Alg Ch Pair4
5
6Affect Vol
7Chan Output
8Mute w/ HP
Unit Info
Hardware Configuration
Menu
Screen Saver1
2
Analog Ref3
AES Term4
System Reset 5
Scrn Bright 6
7
AES Term All 8