User guide

821697: AMP1-16 Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
6
Chapter 1 Quick Start
Getting Started
the setup menus. (The pin out of this connector is shown in Table 2–
3 on page 17.)
• AES Outputs: Each of these two HD-15F connectors supplies four
pairs of unbalanced AES outputs for a total of eight. The source of
these signals is determined by the setup menus. (The pin out of
these connectors is shown in Table 2–2 on page 16.)
• AES Inputs: Each of these eight BNC connectors provides an
unbalanced AES input. The monitoring of these signals is
determined by the setup menus.
• 3G/HD/SD-SDI Inputs: These two BNC connectors input two
separate SDI signals. Front panel controls select between the two for
monitoring or down converting.
• 3G/HD/SD-SDI Re-Clocked Output: This BNC connector outputs
a re-clocked replica of the selected 3G/HD/SD-SDI input signal.
Getting Started
Once you have connected a 3G/HD/SD SDI video signal to one of the
video inputs on the back of the unit, it should display on the video
monitor after a few seconds.
Figure 1–3 Video Monitor Display (Left)
To begin any procedure on the AMP1-16-3G or the AMP1-E16-3G,
powering up the system should display the video input on the left