User guide

821697: AMP1-16 Series User Guide

Chapter 1 Quick Start

Installation Recommendations

Mounting

The unit is designed to install into a standard 19" rack, mounted at eye

level for best visual observation of the monitor screens. After installing

the AMP1-16-3G, remove the clear, plastic protective covers from each

screen using the tabs provided.

Heat Dissipation

The ambient temperature inside the mounting enclosure should not

exceed 40° Celsius (104° Fahrenheit). Adjacent devices can be rack

mounted (or stacked) in proximity to the unit if the above temperature

is not exceeded. If the product must be operated in an environment

with an elevated temperature, allow a 1RU (1.75”/44.45mm) space

above and below the unit for air circulation.

Power

The AMP1-16-3G has a standard IEC connector on the rear panel from

which it can connect to AC mains power (100 to 240 VAC ± 10%, 50/60

Hz, 65W). You may use the power cord provided, or another approved

cord, to adapt the unit to the proper country-specific power connection.

FCC Compliance

This equipment has been tested and found to comply with the limits for

a Class A digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial

Important:

To reduce noise, neither the AMP1-16-3G nor the AMP1-E16-3G have

any fans. As a result, the heat generated by the class D power

amplifiers, power supplies, and other components is vented by slots in

the sides of the unit. Therefore, as a safety precaution, we advise you to

be sure to allow proper ventilation on both sides of the unit.