User guide

821024: AMP1-DA/106 User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
17
AMP1-DA/106 User Guide
Rear Panel 10-Position DIP Settings for the Level Meters
position rear panel DIP switch is located). See page*** for a diagram of
the PCB and the DIP switch location.
Figure 1–9 Internal 10-Position DIP Switch
Settings
Switch positions 1 and 10 are not used and should be left at the factory set
position.
The Peak Hold - Manual setting allows the bargraph display meters to
indefinitely maintain the peak hold value until it is reset by the operator,
either by pressing a reset button (a special option specified at time of
order) or by removing power and then reapplying power
to the unit (unplug/replug power cord). Contact Wohler Technologies
for more information about this feature.
Contact Wohler Technologies for information about custom scales.