User guide

821024: AMP1-DA/106 User Guide

AMP1-DA/106 User Guide

Rear Panel Connectors

• AES/EBU Input Termination and AES Error Fault Type DIP

Switches:

• AES Input Termination: In the event that either of the AES

input channels is connected to downstream equipment, set

the appropriate switch to the up position (unterminated). If no

downstream equipment is connected, then set to the down position

(terminated). See Figure 1–4 below termination settings.

Figure 1–4 AES In 1 and 2 Termination Settings

• AES Error Fault Type: Two selectable DIP switch modes of

fault detection create a red error indication in the AES/EBU

Signal Status Indication LED when the unit detects:

1) Reception Errors: Errors in reception of data or no data

stream at all (1 = down) or,

2) Reception and Data Errors: Errors in reception and data

errors identified by the sending device (possibly invalid)

(1 = up). See Figure 1–5 below for error settings.

Figure 1–5 AES Error Indication Settings