User guide

821024: AMP1-DA/106 User Guide

AMP1-DA/106 User Guide

Front Panel Controls

Figure 1–2 AMP1-DA/106 Front Panel

• Speakers: The AMP1-DA/106 speaker system is comprised of two

mid-range tweeter speakers (left and right) and two woofer

speakers (left and right). The two mid-range speakers reproduce, in

stereo, only the mid and high frequencies, while the two woofer

speakers monorally reproduce the low frequencies.

• Headphone Jack: This jack accepts a standard 1/4" stereo (ring/

tip/sleeve) phone plug. Select the headphone audio sources as you

would for the internal speakers. When you plug in headphones, the

internal speakers will mute.

• Bar Graph Brightness: This control is recessed into the front panel

and can be accessed using a small flathead screwdriver. Turning the

trim pot clockwise will simultaneously increase the relative

brightness of the LED segments in both bargraphs.

• Audio Level Meters: Audio levels for the selected input sources are

displayed via these two 106-segment tri-color (green, amber, red)

LED bargraph display level meters. These two bargraph displays

feature an Auto-Calibration feature and are user adjustable for

Display Mode and Reference Level via a rear panel DIP module.

Peak Hold, PPM Ballistics, and Alternative Scales can be set via an

internal DIP module. See pages 18 and 19 for more information

regarding these DIP switch module locations and settings.

• Digital Source Select Switch: This switch selects between the two

AES/EBU In (In 1 or In 2) source inputs. Note that for the

selected AES source to be monitored, the

Analog/Digital Source

Select

switch must be set to Digital.

Speakers

Headphones

Brightness

Volume

Power

Level Meters

AES

Indication

AES Select

Balance

Analog/Digital Select