User guide

AMP V Series User Guide

Line Level Calibration Instructions

• AES Out from SDI (1 and 2, on BNC): These two unbalanced (75

) loop-through connectors each output a copy of the de-embedded

audio from the SDI input.

• AES Termination (Four-Position DIP Switch): This DIP switch sets

the termination for the AES inputs. If an AES input channel is fed to

downstream equipment, the associated DIP switch must be in the

up position (unterminated). If no downstream equipment is

connected, the switch must be in the down position (terminated).

See Figure 1–8 for details.

• SDI In and Out (BNC-F): This unbalanced (75 ) input connector

receives standard SD-SDI signals. The unit monitors Subgroup 1

(Channels 1 and 2) and Subgroup 2 (Channels 3 and 4) of SDI

Group 1. Note that the unit will monitor the SDI input only when

the Analog/Digital source select switch is set to Digital, and the

AES/SDI digitial source select switch is set to SDI.

The unbalanced (75 ) SDI Out loop-through connector outputs a

reclocked copy of the signal entering the SDI In connector.

• Analog Out from Selected Digital Source (3-Pin Phoenix Male,

Outputs 1 through 4): The balanced (75 ) connectors ouput analog

signals converted from the selected digital inputs (but not the

analog inputs). These outputs are not affected by the position of the

Analog/Digital souce select switch. The pin-out is silk-screened

onto the the rear panel.

Line Level Calibration Instructions

Figure 1–11 Calibration Settings