User guide

© 2010 Wohler Technologies, Inc. All rights reserved.
16
AMP V Series User Guide
Rear Panel Connectors
• Converted Analog Out (Converted from AES Inputs) (Phoenix, 3-
Pin Male, Outputs 1 through 4): These connectors output standard,
balanced analog signals converted from the AES digital inputs (but
not the analog inputs) and are not affected by the position of the
Analog/Digital source select swich.
AMP2-VSDA-Specific Connectors
Figure 1–10 AMP2-VSDA Rear Panel
• AES In (1 & 2, on XLR-F): These input connectors receive industry
standard, balanced (110 ) AES signals. Note that the unit will
monitor the AES inputs only when the Analog/Digital source
select switch is set to Digital and the AES/SDI source select switch
is set to AES.
• AES In (1 & 2, on BNC): These input connectors receive industry
standard, unbalanced (75) AES signals. Note that the unit will
monitor the AES inputs only when the Analog/Digital source
select switch is set to
Digital.
S
DIGITAL SOURCE
SELECTED
ANALOG OUT FROM
12
3
www.Wohler.com
Fax
Tel
Technologies
Wohler
[phone]
[phone]
253358
AMP2-VSDA
CALIB.
GAIN
TERM 1
2
CH 1 CH 2
ANALOG IN
CH 3 CH 4
AES/EBU PORTS
SDI
OUT-FROM
AES
AES
IN 1
AES
IN 2
OUT-FROM
AES
SDI
OUT
SDI
IN
AES IN 1 AES IN 2
0 -18
-20
-9
+4
+6
GAIN CALIB
DIGITAL
-20
dBFS
+8
dB
HI
LO
HI
LO LO
HI HI
LO
1
23
4
CALIBRATE
1
3
2
5
4
OPERATE
6
SEL. ANALOG OUT
CH A (L) CH B (R)
100-240 VAC
50/60 Hz 1.0 A
YEAR
MONTH
SERIAL NO.
3
2
1
3
21 2
3
1
3
21
3
21
3
21
1 2
3
MADE IN U.S.A.
Power
AES In 1 & 2
Gain Calibration
Analog Out from
Selected Digital Source
Analog Audio In (1 thru 4)
AES/EBU In 1 & 2 and
AES Out from SDI 1 & 2
AES
Term
SDI I/O
Line Level Calibration
Selected Analog Audio Out L & R
Important:
Do not input signals simultaneously to the AES BNC connectors and
the AES XLR connectors of the same channel (i.e., BNC AES In 1 and
XLR AES In 1.
Important:
Do not input signals simultaneously to the AES BNC connectors and
the AES XLR connectors of the same channel (i.e., BNC AES In 1 and
XLR AES In 1.