User guide

821027: AMPx-SDA User Guide

AMPx-SDA User Guide

Rear Panel Connectors

Figure 1–5 AES DA Conversion Gain Calibration

Settings

• SD-SDI In and Out:The

SDI In female BNC connector is meant to

receive standard SDI signals. The

SDI Out female BNC connector

outputs a reclocked (regenerated) copy of the signal entering the

SDI In input connector. Both connectors are configured for

unbalanced, 75 Ω connections. Note that the unit will monitor the

SDI input only when the Analog/Digital Source Select switch is

set to Digital and the Digital Source Select switch is set to SDI.

• Selected Analog Out (from Digital Source): These two 3-pin male

XLR connectors are analog outputs of the selected digital source as

selected for the left and right speakers and level meters. The left

connector outputs the left channel (or Channel A) and the right

outputs the right channel (or Channel B). Both connectors are

configured for low impedance connections and the output signals

are not affected by the Volume/Balance controls or headphone

mute. For XLR pinout information see Figure 1–6 below.

Figure 1–6 XLR Pin-Outs

Note:

All SDI signals are SD-SDI (Standard Definition).

Female

Male