User guide

821027: AMPx-SDA User Guide

AMPx-SDA User Guide

Rear Panel Connectors

• SDI Signal Error LED: This LED, labeled SDI glows green as

long as a valid SD-SDI digital datastream is being received. It

glows red if TSR errors are present in the signal. If there is no

SD-SDI signal present the LED will be unlit.

Rear Panel Connectors

Common Connectors

• Power: Attach a standard IEC-320 power cord between this

connector and mains power (100 - 250VAC, 50/60 Hz). The front

panel Power LED will glow green to indicate operating voltages are

present.

• AES Out (From SDI): The AES/EBU Out outputs an AES/EBU

signal as converted from the SDI input and as selected by the SDI

Group Select

switch. This connector is configured for an

unbalanced, 75 W connection.

• AES Termination and Error Type DIP Switch: This 4-position DIP

switch is used to set the termination characteristics for the AES

inputs and select the AES signal error indication type.

• AES Input Termination: In the event that the AES input

channel is fed to downstream equipment (via a "Y" or "T"

connector), then DIP switch Section S2 must be placed in the

unterminated (up) position. If there is no downstream

equipment connected, then Section S2 must be placed in the

terminated (down) position. See Figure 1–3 below termination

settings.

Figure 1–3 AES Termination Settings