User guide

821091: AMP1-MADIe User Guide

Appendix A Connecting the AMP1-MADIe to a LAN

Adding Your AMP1-MADIe to Your Network

6. Click Refresh. After the system polls the network, all the

AMP1-MADIes on the network will display in the Units

Responding

box.

7. In the event that the AMP1-MADIe you’re looking for does not

appear in the

AMP1-MADIe Units box, click Locate IP to

display the following dialog so you can enter the IP address of the

AMP1-MADIe unit you’re looking for.

Figure A–4 Enter AMP1-MADIe IP Address Dialog

A. Enter the

IP Address of the AMP1-MADIe that you’re trying

to locate on the network.

B. Enter the

IP Mask.

C. Click Find.

8. On the outside chance, the monitor does not automatically show

up in the

AMP1-MADIe Units area, click the Refresh button.

Note:

This could happen over a WAN where VPN access is

used since most WAN configurations do not allow

searching for units with the methods used by this

equipment.

Enter AMP1-MADIe IP Address

IP Address

IP Mask 255.255.255.255

Find Cancel

255.255.255.255

Important:

You must see your AMP1-MADIe listed in the AMP1-MADIe Units

area. If not, double-check your connections. If the monitor still does

not display, call Wohler’s technical assistance. (See Wohler’s contact

into on page ii.)