User guide

821091: AMP1-MADIe User Guide

Appendix A Connecting the AMP1-MADIe to a LAN

Adding Your AMP1-MADIe to Your Network

Figure A–3 Configure AMP1-MADIe IP Address

Dialog

5. When the

Configure AMP1-MADIe IP Address dialog

displays, do the following:

A. Click the Use DHCP check box (if needed) to select DHCP.

B. If your network does not use DHCP, enter the Unit IP

Address

C. If your network does not use DHCP, enter the

Unit IP Mask.

D. Type in up to 16 characters to give this unit an unique,

human-readable Unit Name. This will prove helpful if you

have more than one AMP1-MADIe.

E. Click OK to close the dialog.

Configure AMP1-MADIe IP Address

IP Address 0.0.0.0

IP Mask

0.0.0.0

Direct Connect

Use DHCP

Unit Name

Master Control 3

Update Update

Important:

If your network uses DHCP, then skip Steps B and C and continue on

to Step D below.

Important:

The name you select for this AMP1-MADIe should denote its position

or function within your facility so that it can be easily recognized later.

Note:

To change the IP settings, the unit must restart. The

Windows application will automatically restart the

unit, and display the unit with its new address

after it has rebooted. This takes approximately 10

seconds.