User guide

821091: AMP1-MADIe User Guide
© 2012 Wohler Technologies, Inc. All rights reserved.
45
Chapter 4 Internal Menu System
Version and Ethernet Menu
Version and Ethernet Menu
This menu displays software and hardware versions, as well as
Ethernet settings. By default, the DHCP setting is enabled and the IP
Address and IP Mask settings are shown as 0.0.0.0. This means it will
automatically attempt to get the needed IP Address and IP Mask
settings from the network.
Figure 4–7 Version and Ethernet Menu
• Factory Default: Pressing this button opens a cautionary window
to verify that you really want to restore the AMP1-MADIe setup to
the factory default. If you press the Factory Default button again,
the action proceeds and the unit will restart. Otherwise, after five
seconds, the factory default request is cancelled. You can also cancel
the factory default request by pressing any other button.
• Set (IP Address or IP Mask): Pressing this button highlights the
first of the four octets, turning the Channel Volume knob
clockwise increases the octet; turning it counterclockwise reduces
the octet. Pressing either the Set IP Address or the Channel
Volume
knob advances the highlight to the next octet. Advancing
beyond the last octet returns the highlight to the first octet.
• Addr Mode: Pressing this button selects between DHCP and
Static address modes.
Version & Ethernet Menu
Back
Factory
Default
Unit Name:
<Not Set>
Application Ver: 01.00
NvRam Table Ver: 01.00
Bootloader Ver: 01.00
Audio FPGA Ver: 01.00
Graphics FPGA Ver: 01.00
Main PCA Ver: 01
Graphics PCA Ver: 01
Finished
Ethernet IP Address
IP Address: 0
IP Mask: 0
0
0
0
0
0
0
Press Set to select the item;
turn the Trim control adjust.
DHCP mode enabled
10.0.0.0
Set
Addr Mode:
DHCP
Connect:
LAN
To quickly exit Menus, press Channel Volume for 3 seconds
Note:
The Factory Default action restores the entire unit to
its factory condition. The unit name is deleted, the IP
Address
is set to DHCP, and the Connect: setting is
reset to LAN.