User guide

821091: AMP1-MADIe User Guide

Chapter 3 AMP1-MADIe Graphical User Interface (GUI) Manager

The Ethernet Tab

Units Responding

The large window in the Units Responding area displays all the

AMP-MADIes that the application found on the network.

• Refresh: Clicking this button causes the system to poll the network

to find all the AMP1-MADIes on the network.

• Locate IP: Clicking this button displays the Enter AMP1-MADIe

IP Address

dialog. Enter the IP Address and IP Mask of the unit

to which you are trying to connect, and then click Find. If the

specified unit is on the network, it will display in the Units

Responding

list.

• Config IP: To enable this button, click any one of the

AMP1-MADIe units in the Units Responding list. Once you have

selected a unit, the system enables the button. Clicking this button

displays the Configure AMP1-MADIe IP Address dialog. Click

either Use DHCP or Direct Connect to set a static IP Address

and IP Mask. For either type of network, you can also add a

human-readable Unit Name to identify this unit’s function/

location. Click Update and then click Refresh, if needed.

• Update: After selecting an AMP1-MADIe from the Units

Responding

list, clicking this button displays a dialog warning

you that the system is about to update the software in the selected

unit. Click Cancel abort, or OK or to continue. After updating the

selected unit, the system will restart it and display the Update

Complete

dialog. Refer to Appendix B on page 61 for more

information.

• Disconnect from Remote Unit: Should you need to unselect an

AMP1-MADIe to prevent making further configuration changes,

you can either select a different unit, or click

Disconnect from

Remote Unit

Documentation

• Readme: Clicking this button displays the readme.txt file for the

downloaded software updates.

• Open Log: Clicking this button allows you to save the

Update Log

file.