User guide
821091: AMP1-MADIe User Guide
© 2012 Wohler Technologies, Inc. All rights reserved.
29
Chapter 3 AMP1-MADIe Graphical User Interface (GUI) Manager
The Options Tab
When you start the AMP1-MADIe Manager, it automatically recalls the
Facility configuration file. The settings in the Facility configuration
file copy over the settings in the Channels tab, the Preset tabs, and
the Options tab. You can send this configuration to the selected
AMP1-MADIe without changes, or you can modify it and then send it
to the selected unit. The controls on the Facility tab are listed below.
• Save Facility Configuration: You can set up a system
configuration, including all presets and options and save it as your
facility file.
• Reset Facility Configuration: You can also reset the facility
configuration file back to the way it was when it left the factory.
• Open Facility Configuration: Recall all the channel settings,
options, and presets that pertain to your facility.
The Options Tab
Figure 3–6 Options Screen
Wohler AMP1-MADIe Manager v01.00
Phones
Always
Never
Speaker Mute
Meter
Scale
Default
Level Meters
0 dBr = 0 dBFSReference
Meter
Segments
13
19
23
-30 dBFS
-20 dBFS
Scale
Float
Bar
AES
IEC1
Average
22
22
8 hrs
Screen
Saver
Left
Right
Screen Brightness
Fixed Level & Mute Controlled
Channel Volume Controlled
Analog Output
Master Volume Controlled
Select Preset
Chan Assign
Functions Enabled
Menu System
MADI BNC
MADI Optical
Input Selection
Audio Delay
4 mS
No Delay
Pre Fade
Metering Mode
Post Fade
Channel Knob Acceleration
On Off
0 dB
0 dB
Bass
Treble
Tone Controls
Flat
Speaker Response
Channels Preset 2 Preset 3 Preset 4 Preset 5 Preset 6 Preset 7 Preset 8 Options Ethernet USBCurrentPreset 1 Facility