User guide

821091: AMP1-MADIe User Guide

Chapter 3 AMP1-MADIe Graphical User Interface (GUI) Manager

The Facility Tab

You can, however, use this screen to perform all of the following:

1. Copy the settings from another preset into this one using the Copy

Settings from Preset

button. Enter the preset number and then

click the button.

2. Select any MADI channel to any monitoring position. Click the

drop-down menu to select the monitoring position for this

channel.

3. Assign a channel on each monitoring position to left, right, or both

speakers and analog outputs. Click the drop-down menu to select

either L (left, R (right), or C (center).

4. Set the volume level for each channel by using the Channel

Volume dB

section settings. Enter any value from -61 dB (Mute)

to 0 dB (Max).

The Facility Tab

Figure 3–5 Facility Tab

You can access the

Facility tab whether an AMP1-MADIe is connected

or not. It is a complete AMP1-MADIe configuration, including all

channel settings, all presets, and all options and intended to contain the

basic settings that are typically needed facility-wide. You can only have

one facility configuration file at a time.

Note:

The name of the Current Preset cannot be changed: it is

always called the Current preset.

Wohler AMP1-MADIe Manager v01.00

Preset 1

Channels Preset 2 Preset 3 Preset 4 Preset 5 Preset 6 Preset 7 Preset 8 Options Ethernet USBCurrentPreset 1 Facility

Facility Configuration

Save Facility Configuration

Open Facility Configuration

Save the current settings, including all Channel settings, Options and all

8 Presets to the Facility Configuration file. The saved Facility

Configuration will be loaded into this program each time it starts up.

Reset Facility Configuration

Reset the Facility Configuration, including all Channel settings, Options

and all 8 Presets to the original factory configuration and then save

them.

Recall the current settings from the saved Facility Configuration file,

including all Channel settings, Options and all 8 presets.