User guide

821091: AMP1-MADIe User Guide
© 2012 Wohler Technologies, Inc. All rights reserved.
17
Chapter 2 Operation
Using the Balanced Analog Outputs
Figure 2–6 Options Menu
In this menu, press either BNC or Fiber. Press the Channel Volume
knob for at least three seconds. This menu contains a variety of useful
options that can be used to customize the AMP1-MADIe to your needs.
Refer to Chapter 4 for details.
Using the Balanced Analog Outputs
The AMP1-MADIe contains Left and Right channel outputs, as well as
a Mono Mix output. By default, these balanced analog outputs
produce line level signals and are unaffected by the Master Volume,
Balance, and Channel Volume controls. They output all unmuted
channels, as indicated by the bright blue icons in the middle of the
Main Screen.
Optionally, you can configure the system so that the
Channel Volume
controls and/or the Master Volume and Balance controls will
control the balanced analog outputs. This configuration is useful if you
will be using external amplifiers and speakers. To do this, press the
Channel Volume button for at least three seconds until the Audio
Menu 1
appears (Figure 2–7 below).
Options Menu
NextBack
8 hrsScreen Saver
Press to select, then turn the
Trim control to adjust .
MADI Input
Multimode Fiber Input
Coax Copper Input BNC
Fiber
Screen Bright
22 22
Left Right
To quickly exit Menus, press Channel Volume for 3 seconds
ON
Chan Volume
Acceleration