User guide

821091: AMP1-MADIe User Guide

Chapter 2 Operation

Selecting the Multimode Optical Input

Figure 2–5 Audio Menu 2

Pressing the

Flat button brightens the Flat setting and darkens the

Bass and Treble settings to brown, and produces a flat response. This

is the default setting. However, the Bass and Treble settings are

retained so you can recall them the next time you press either the Bass

or Treble button.

Press either Treble or Bass and then rotate the Channel Volume to

increase or decrease the response of each. The range is

± 12 dB in 2 dB steps.

Press the Channel Volume knob for at least three seconds to return to

the Main Screen.

Selecting the Multimode Optical Input

The AMP1-MADIe can monitor either the BNC or the multimode

optical fiber inputs on the rear panel.

1. To switch between the two, hold the Channel Volume knob for

at least three seconds until the

Audio Menu 1 displays.

2. Press the Next button twice to proceed to the Options Menu.

Audio Menu 2

Flat response, tone controls

set to 0 dB

Flat

NextBack

Tone Controls

To quickly exit Menus, press Channel Volume for 3 seconds

0 dB

Bass

Treble

The Tone

Controls

affect the

speaker

sound only.

4 ms Audio Delay

Note:

The tone controls only apply to the internal speakers, not to

the analog outputs or headphone output.