User guide

82 10 91: A M P1 - MA DI e Use r Gu id e
© 2013 Wohl er Tec hn ologi e s , In c . Al l r ig h ts re se rved.
75
Ap pe nd ix B Software Upgrades
Up g ra di ng th e A MP 1- M AD Ie vi a a D i rec t C o nn e c tio n
5. Turn the unit on, and set the unit for direct mode and DHCP. This
can be done in the Version and Ethernet Menu, Connect:
Direct.
Figure B–11 Version and Ethernet Menu
6. Press Finished. The unit may restart if it was not previously set to
direct mode.
7. On your host computer, close any running applications, especially
those using the internet or maintaining a VPN (virtual private
networking) connection.
8. If your host computer has multiple network interfaces (such as
wireless and wired Ethernet), disable the ports you will not be
using (especially wireless port(s)).
9. Restart your computer.
10. Start the MADIe Manager, and complete any desired operations.
11. When finished, disconnect the computer from the unit.
12. Be sure to disable the Direct Mode on the unit, and return to the
previous Ethernet settings if connecting to a LAN.
13. Enable any network interfaces on the computer that were disabled
and restart the computer.
Note:
You might want to write down the values for the IP
Address, IP Mask, and Gateway so you can reset
them later.
Version & Ethernet Menu
Back
Factory
Default
Unit Name:
<Not Set>
Application Ver: 01.28
NvRam Table Ver: 01.02
Bootloader Ver: 01.13
Audio FPGA Ver: 01.11
Graphics FPGA Ver: 01.16
Main PCA Ver: 02
Graphics PCA Ver: A 02
Fiber I/O: Multi-Mode
Finished
Ethernet IP Address
IP Addr: 000
IP Mask: 000
000
000
000
000
000
000
Press Set and turn TRIM to
select the desired number.
DHCP Current Info:
Addr: 192.168.001.129
Mask: 255.255.255.255
Gate: 192.168.001.016
Set
Addr Mode:
DHCP
Connect:
LAN
To quickly exit Menus, press Channel Volume for 3 seconds
Gateway: 000 000 000 000
Reload Last
Config