User guide

8 21 09 1 : AM P 1- MAD Ie Us er G u ide

Ap pe nd ix B S oftw a re U p gra de s

Up g ra di n g th e A M P1- M AD Ie v ia a Di re ct Co n nec ti on

Upgrading the AMP1-MADIe via a

Direct Connection

A direct connection should only be used when a LAN (local area

network) is not available or is not connected to the unit. A direct

connection to any unit can be tricky if you're not familiar with setting

static IP addresses. Fortunately, this unit has a DHCP server

embedded in it, which will make a direct connection much easier. All

of these instructions may not be needed in your particular situation, but

following them ensures success.

1. Ensure the computer has the latest MADIe manager installed by

opening the application and choosing Check for Updates shown

in Figure B–10 below. In some cases, you may need to download a

new manager from www.wohler.com.

Figure B–10 USB Tab

2. Disconnect the computer from any LAN.

3. Make sure the unit is NOT connected to a LAN (Local Area

Network). If it is, disconnect it.

4. Connect the unit to the host computer through either a standard

network "patch" cable or "crossover" cable. The unit will

recognize which is being used automatically, and act accordingly.

Wohler AMP1-MADIe Manager v01.00

USBChannels Preset 2 Preset 3 Preset 4 Preset 5 Preset 6 Preset 7 Preset 8Preset 1 Options Ethernet

Programming Files

Connection Type

Flash Drive Files

Save to FlashRead from Flash Rename

Flash Drive Connected

Drive <No Drive>

Eject

Current

File Name

Channels Preset 2 Preset 3 Preset 4 Preset 5 Preset 6 Preset 7 Preset 8 Options Ethernet USBCurrentPreset 1 Facility

File #

Programming Files

Check for Updates

Create Update on Flash Drive