User guide

82 10 91: A M P1 - MA DI e Use r Gu id e
© 2013 Wohl er Tec hn ologi e s , In c . Al l r ig h ts re se rved.
71
Ap pe nd ix B Software Upgrades
Up g ra din g th e A MP 1- M AD Ie Ov e r Et her n et
Upgrading the AMP1-MADIe Over
Ethernet
Checking for Updates
Before establishing the connection to the AMP1-MADIe, you should
check to see if any software updates are currently available.
1. Launch the AMP1-MADIe Manager from your PC’s desktop.
2. Click the Ethernet tab.
Figure B–6 AMP1-MADIe Manager SDI Ethernet
Screen
3. Click Show Local File Versions to display the versions of the
programming files on your hard drive.
4. Click Check for Updates. At this point, the system will respond
with one of two dialogs:
A. No New Updates: In the event that no new updates are
available, the system will display the dialog shown in Figure
B–7 below.
Wohler AMP1-MADIe Manager v01.00
EthernetChannels Preset 2 Preset 3 Preset 4 Preset 5 Preset 6 Preset 7 Preset 8Preset 1 Options USB
File Update Options
Update as Needed
Update all
Programming Files
Check for Updates
Show Local File Versions
Documentation
Readme ManualOpen Log
Channels Preset 2 Preset 3 Preset 4 Preset 5 Preset 6 Preset 7 Preset 8 Options Ethernet USBCurrentPreset 1 Facility
Units Responding
Locate IP Config IPRefresh Update
IP Address Unit Name MAC Address Unit Type
Disconnect From Remote Unit
192.168.0.50 Production 00-00-03-45-67-89 AMP1-MADIe