User guide

8 21 09 1 : AM P 1- MAD Ie Us er G u ide
© 2 01 3 Woh le r Te ch nolo gie s, Inc . All ri g ht s res e r ve d.
70
Ap pe nd ix B S oftw a re U p gra de s
Up g ra di n g th e So f tw ar e Us ing a U S B Fl a sh D ri v e
A. Press the Update Software as Needed button to install
only newer software versions contained in the flash drive into
the AMP1-MADIe. The next screen to appear will describe
what to expect in the installation process.
B. Alternatively, you can press the Replace Software
Unconditionally button to install the software contained in
the flash drive into the AMP1-MADIe, even if it the same
version already is installed and even if the flash drive version
is a lower version than what is already installed. The next
screen to appear will describe what to expect in the
installation process.
After you have selected a software installation option, the system
will display the Software Update screen shown in Figure B–5
below.
Figure B–5 The Software Update Screen
Pressing Start the Update button will start the installation process,
which will automatically continue until its conclusion. Instructions are
provided on this screen to explain the process. When the software is
finished installing, the AMP1-MADIe will restart and the Main Screen
will display.
Alternatively, you can press the Cancel/Quit button to return to the
Flash Drive Software Update menu and not perform the software
update.
Cancel/Quit
The software update is
ready to start. Please
read the following first:
This software installation may take
1 - 5 minutes. Do not remove power or
the USB device. The screens may go
blank and the unit may restart several
times. A message will be displayed
when the installation is complete.
Please wait for this!
To exit without
installing software,
press Cancel/Quit
Start the Update
Press Start the Update
when ready
Im p ort an t:
This concludes the AMP1-MADIe software upgrade procedure.