User guide

82 10 91: A M P1 - MA DI e Use r Gu id e
© 2013 Wohl er Tec hn ologi e s , In c . Al l r ig h ts re se rved.
69
Ap pe nd ix B Software Upgrades
Up g ra di n g th e So f tw ar e U s ing a U S B Fl a sh D ri v e
(Optional) Before updating the software in the AMP1-MADIe, you
may want to compare the versions already installed versus the
new version in the software update. Pressing the View Versions
button displays the Software Update Versions screen shown in
Figure B–3 below.
To abort the process, press the Cancel/Quit button to cancel the
update request and return to the Flash Drive Connected menu
instead.
Figure B–3 View Versions Screen
2. From the Software Update Versions menu, press Return to
Last Menu to return to the Flash Drive Software menu shown in
Figure B–4 below.
Figure B–4 Flash Drive Software Update
3. If the screen does not indicate that the software is up to date, you
can select one of two update options:
Software Update Versions
Return to
Last Menu
Application Ver: 01.00
NvRam Table Ver: 01.00
Bootloader Ver: 01.00
Audio FPGA Ver: 01.00
Graphics FPGA Ver: 01.00
Current Versions:Update Versions
Application Ver: 02.00
NvRam Table Ver: 02.00
Bootloader Ver: 02.00
Audio FPGA Ver: 02.00
Graphics FPGA Ver: 02.00
Flash Drive Software Update
Update Software
as Needed
Cancel/Quit
To exit without installing
software,
press Cancel/Quit
View Versions
The installed software
is up to date.
Update only the outdated
parts of the software.
(Recommended)
Replace Software
Unconditionally
Update the software
regardless of version.
(Use cautiously)
Note:
In Figure B–2, the software version is up to date and no
update is needed.