User guide

82 10 91: A M P1 - MA DI e Use r Gu id e

A ppe n di x A Connecting the AMP1-MADIe to a LAN

A ddi n g Y o u r AM P 1 - MA D Ie to Y our Ne tw or k

E. Click OK to close the dialog.

6. Click Refresh. After the system polls the network, all the

AMP1-MADIes on the network will display in the Units

Responding box.

7. In the event that the AMP1-MADIe you’re looking for does not

appear in the AMP1-MADIe Units box, click Locate IP to

display the following dialog so you can enter the IP address of the

AMP1-MADIe unit you’re looking for.

Figure A–4 Enter AMP1-MADIe IP Address Dialog

A. Enter the IP Address of the AMP1-MADIe that you’re trying

to locate on the network.

B. Enter the IP Mask.

Note:

To change the IP settings, the unit must restart. The

Windows application will automatically restart the

unit, and display the unit with its new address

after it has rebooted. This takes approximately 10

seconds.

Note:

This could happen over a WAN where VPN access is

used since most WAN configurations do not allow

searching for units with the methods used by this

equipment. This is also necessary when the Windows

host and the unit are on different subnets of the

network.

Enter AMP1-MADIe IP Address

IP Address

IP Mask 255.255.255.255

Find Cancel

255.255.255.255