User guide

8 21 09 1 : AM P 1- MAD Ie Us er G u ide
© 2 01 3 Woh le r Te ch nolo gie s, Inc . All ri g ht s res e r ve d.
64
Ap pe nd ix A C o nn ec t in g t he AM P 1 -MA D Ie t o a L A N
Ad din g Y our A M P1 -M AD Ie to Yo u r N e tw ork
Figure A–3 Configure AMP1-MADIe IP Address
Dialog
5. When the Configure AMP1-MADIe IP Address dialog
displays, do the following:
A. Click the Use DHCP check box to select DHCP.
B. If your network does not use DHCP, enter the Unit IP
Address.
C. If your network does not use DHCP, enter the Unit IP Mask
and Gateway.
D. Type in up to 16 characters to give this unit an unique,
human-readable Unit Name. This will prove helpful if you
have more than one AMP1-MADIe.
Configure AMP1-MADIe IP Address
IP Address 0.0.0.0
IP Mask 0.0.0.0
Direct Connect
Use DHCP
Unit Name Master Control 3
Update Cancel
Gateway 0.0.0.0
Im p ort an t:
If your network uses DHCP, then skip Steps B and C and continue on
to Step D below. Use this option if your local area network
automatically provides the IP information for the unit when it is
connected.
Be sure to check with your network administrator to obtain valid static
settings for this device. Failure to do so may cause intermittent
problems to appear on the entire network.
Im p ort an t:
The name you select for this AMP1-MADIe should denote its position
or function within your facility so that it can be easily recognized later.