User guide

82 10 91: A M P1 - MA DI e Use r Gu id e
© 2013 Wohl er Tec hn ologi e s , In c . Al l r ig h ts re se rved.
63
A ppe n di x A Connecting the AMP1-MADIe to a LAN
A ddi n g Y o u r AM P 1 - MA D Ie to Y our Ne tw or k
Figure A–2 AMP1-MADIe Manager Ethernet Tab
If the unit does not appear, click the Refresh button.
Adding Your AMP1-MADIe to Your
Network
1. If you have not already done so, connect an Ethernet cable from
the Ethernet port of the AMP1-MADIe (labeled Ethernet) to the
network.
2. Click Refresh.
3. Click on the unit you wish to configure in the Units Responding
list.
4. Click Config IP.
Wohler AMP1-MADIe Manager v01.00
EthernetChannels Preset 2 Preset 3 Preset 4 Preset 5 Preset 6 Preset 7 Preset 8Preset 1 Options USB
File Update Options
Update as Needed
Update all
Programming Files
Check for Updates
Show Local File Versions
Documentation
Readme ManualOpen Log
Channels Preset 2 Preset 3 Preset 4 Preset 5 Preset 6 Preset 7 Preset 8 Options Ethernet USBCurrentPreset 1 Facility
Units Responding
Locate IP Config IPRefresh Update
IP Address Unit Name MAC Address Unit Type
Disconnect From Remote Unit
192.168.0.50 Production 00-00-03-45-67-89 AMP1-MADIe
Im p ort an t:
If your network is configured for DHCP, and your screen displays
your AMP1-MADIe in the Units Responding list, you have
successfully completed your network connection.
Note:
Usually, you will set up the IP address of your
AMP1-MADIe using the Versions and Ethernet menu on
the unit. This section is provided when only remote access is
available.