User guide

82 10 91: A M P1 - MA DI e Use r Gu id e
© 2013 Wohl er Tec hn ologi e s , In c . Al l r ig h ts re se rved.
51
Ch apt er 4 Internal Menu System
Ve rsi o n a n d E th e r ne t Men u
• Middle Segment: Pressing this button and then rotating the
Channel Volume knob adjusts the division between the middle
and lower segments. You can adjust the color boundary in one dBr
increments, and it has the same range as the bottom and top limits
of the meter.
• Default: Pressing this button changes the settings on this menu and
on the Meter Type and Reference Menu back to the factory
settings for the chosen scale type.
• Upper, Middle, and Lower Color: Pressing any of these buttons
and then rotating the Channel Volume knob cycles the upper,
middle, or lower color of the displayed sample level meter color
through a wide variety of colors.
Version and Ethernet Menu
This menu displays software and hardware versions, as well as
Ethernet settings. By default, the DHCP setting is enabled and the IP
Address and IP Mask settings are shown as 0.0.0.0. This means it will
automatically attempt to get the needed IP Address, IP Mask, and
Gateway settings from the network.
Figure 4–7 Version and Ethernet Menu
• Reload Last Config: Pressing this button returns the system to the
last configuration that was loaded either via the Ethernet or from a
USB flash drive.
Version & Ethernet Menu
Back
Factory
Default
Unit Name:
<Not Set>
Application Ver: 01.28
NvRam Table Ver: 01.02
Bootloader Ver: 01.13
Audio FPGA Ver: 01.11
Graphics FPGA Ver: 01.16
Main PCA Ver: 02
Graphics PCA Ver: A 02
Fiber I/O: Multi-Mode
Finished
Ethernet IP Address
IP Addr: 000
IP Mask: 000
000
000
000
000
000
000
Press Set and turn Channel
Volume to select.
DHCP Current Info:
Addr: 192.168.001.129
Mask: 255.255.255.255
Gate: 192.168.001.016
Set
Addr Mode:
DHCP
Connect:
LAN
Gateway: 000 000 000 000
Reload Last
Config
Press and hold Channel Volume to exit menu.