User guide

8 21 09 1 : AM P 1- MAD Ie Us er G u ide
© 2 01 3 Woh le r Te ch nolo gie s, Inc . All ri g ht s res e r ve d.
50
Ch apt er 4 In te rn a l M e n u Sy st e m
Met er S eg m en t Me n u
• Bar: Pressing this button and then rotating the Channel Volume
knob steps through the available settings for the bar ballistics. Refer
to Table 4–1 on page 49.
• Reference: Pressing this button and then rotating the Channel
Volume knob adjusts the reference. Refer to Table 4–1 on page 49
for the reference standards for each scale.The reference is the
relationship between the 0 dBr point of the scale and the digital
input level in dBFS.
• Metering Mode: Pressing this button toggles between Post Fade
and Pre Fade metering modes. The default Post Fade causes the
meters to display the adjusted levels after Channel Volume
adjustments. Pre Fade mode may be used to display the channel
levels before any adjustments.
Meter Segment Menu
On the Meter Segment Menu, you can customize the look of your
meters.
Figure 4–6 Meter Segment Menu
• Upper Segment: Pressing this button and then rotating the
Channel Volume knob adjusts the division between the upper and
middle segments. You can adjust the color boundary in one dBr
increments, and it has the same range as the bottom and top limits
of the meter.
Note:
The AES scale has a fixed reference.
Meter Segment Menu
Set Default
23
19
13
Upper Color
Middle Color
Lower Color
0
-60
-50
-40
-30
-10
-20
-20 dBFS
-30 dBFS
Upper
Segment
Middle
Segment
NextBack
Press a Segment or Color
button and then turn
Channel Volume to adjust.
Press and hold Channel Volume to exit menu.