User guide

82 10 91: AM P1- M AD I e U se r G u ide
© 2013 Wohl er Tec hn ologi e s , In c . Al l r ig h ts re se rved.
39
C hap t er 3 AMP1-MADIe Graphical User Interface (GUI) Manager
The Eth e r n et T ab
File Update Options
Before beginning any update procedure, click either Update as
Needed or Update All.
• Update as Needed should be used for most updates.
• Update All should only be used at the direction of a tech support
representative.
Units Responding
The large window in the Units Responding area displays all the
AMP-MADIes that the application found on the network.
• Refresh: Clicking this button causes the system to poll the network
to find all the AMP1-MADIes on the network.
• Locate IP: Clicking this button displays the Enter AMP1-MADIe
IP Address dialog. Enter the IP Address and IP Mask of the unit
to which you are trying to connect, and then click Find. If the
specified unit is on the network, it will display in the Units
Responding list.
• Config IP: To enable this button, click any one of the
AMP1-MADIe units in the Units Responding list. Once you have
selected a unit, the system enables the button. Clicking this button
displays the Configure AMP1-MADIe IP Address dialog. Check
with your IT administrator to determine what settings are best for
your unit.
The Direct Connect option enables a single-address DHCP server
within the unit. It should only be used if the unit is connected
directly to a Windows computer. Use this option carefully, because
it may cause problems if the unit is actually connected to a local area
network. Selecting this option will force the DHCP checkbox to be
checked, and will disable the other IP entry fields.
The Use DHCP checkbox will cause the unit to query the local area
network to get its IP information. Use this option if your LAN
supports DHCP addressing, and if it is approved by your IT
Note:
To continue with a software upgrade, refer to Appendix
B on page 67.