User guide

82 10 91: AM P1- M AD I e U se r G u ide

C hap t er 3 AMP1-MADIe Graphical User Interface (GUI) Manager

T h e Op t io n s T a b

Metering Mode

Metering Mode: Click to select either Pre Fade or Post Fade.

• Pre Fade: Meters show the levels before the channel volumes are

applied to the input signals.

• Post Fade: (Default) Meters show the levels after the channels are

applied to the input signals.

Screen Brightness

Select the screen brightness for each screen and the duration for the

screen saver.

• Left/Right: Either click the down arrow to increase or decrease the

screen brightness value, or click the field and type in a value.

• Screen Saver: Enter the amount of time you want the monitor to

wait until it invokes the screen saver. Allowable values range (in

one minute increments) from five minutes to 119 minutes, and (in

one hour increments) from two hours to 24 hours. The default

setting is eight hours.

If the AMP1-MADIe is in operation for the screen saver time out

period and no front panel controls have been turned or pressed, the

screens will dim. If double the screen saver time out period elapses

without any front panel control activity, the screens will dim

further. Operating any button or control will instantly brighten the

screens.

Control

Channel Select

• Single: (default) For use in situations where changes are

predominantly made on one channel at a time. It automatically

deselects the last adjusted channel when a new one is selected.

Note:

Using low brightness values and small timeout values

for the screen saver will prolong the life of the LCD

displays.