User guide

82 10 91: AM P1- M AD I e U se r G u ide
© 2013 Wohl er Tec hn ologi e s , In c . Al l r ig h ts re se rved.
33
C hap t er 3 AMP1-MADIe Graphical User Interface (GUI) Manager
T h e Fa c il it y T ab
The Facility Tab
Figure 3–5 Facility Tab
You can access the Facility tab whether an AMP1-MADIe is connected
or not. It is a complete AMP1-MADIe configuration, including all
channel settings, all presets, and all options and intended to contain the
basic settings that are typically needed facility-wide. You can only have
one facility configuration file at a time.
When you start the AMP1-MADIe Manager, it automatically recalls the
Facility configuration file. The settings in the Open Facility
Configuration initialize controls used throughout the manager. You
can send this configuration to the selected AMP1-MADIe without
changes, or you can modify it and then send it to the selected unit. The
controls on the Facility tab are listed below.
• Save Facility Configuration: You can set up a system
configuration, including all presets and options and save it as your
facility file.
• Reset Facility Configuration: You can also reset the facility
configuration file back to the way it was when it left the factory.
• Open Facility Configuration: Recall all the channel settings,
options, and presets that pertain to your facility.
Wohler AMP1-MADIe Manager v01.00
Preset 1
Channels Preset 2 Preset 3 Preset 4 Preset 5 Preset 6 Preset 7 Preset 8 Options Ethernet USBCurrentPreset 1 Facility
Facility Configuration
Save Facility Configuration
Open Facility Configuration
Save the current settings, including all Channel settings, Options and all
8 Presets to the Facility Configuration file. The saved Facility
Configuration will be loaded into this program each time it starts up.
Reset Facility Configuration
Reset the Facility Configuration, including all Channel settings, Options
and all 8 Presets to the original factory configuration and then save
them.
Recall the current settings from the saved Facility Configuration file,
including all Channel settings, Options and all 8 presets.