User guide

82 10 91: AM P1- M AD I e U se r G u ide
© 2013 Wohl er Tec hn ologi e s , In c . Al l r ig h ts re se rved.
23
Ch apt er 2 Operation
US B P or t Fu n ct io n a lit y
Copying a Configuration to the AMP1-MADIe
1. To load a configuration file to the AMP1-MADIe from your flash
drive, press Get. The Get a setup from the Flash Drive screen
will display as shown in Figure 2–13 below. The files that exist on
the flash drive will be lit in bright green.
Figure 2–13 Get a Setup From the Flash Drive Screen
2. From the bright green choices, select the configuration file you
want to copy from the flash drive to the AMP1-MADIe. If you
change your mind and no longer want to get a file, press the
Cancel/Quit button. Once the copy process completes, the Flash
Drive Connected screen re-displays.
3. Remove the flash drive from the USB port.
Copying a Configuration File from the AMP1-MADIe
1. To copy a file to the flash drive from the AMP1-MADIe, press
Save from the Flash Drive Connected screen. The Save to
Flash Drive screen will display as shown in Figure 2–14 on page
24.
Get a setup from the Flash Drive
File 5
File 6
File 7
File 1
File 2
Cancel/QuitFile 4
File 3
Select the Flash
Drive file number
1 to 7 from which
to get a new
AMP1-MADIe
configuration
To exit without making
any changes, press
Cancel/Quit
Note:
The configuration takes effect immediately when you
press the File button. It includes all eight presets plus
the current configuration.