User guide

82 10 91: AM P1- M AD I e U se r G u ide
© 2013 Wohl er Tec hn ologi e s , In c . Al l r ig h ts re se rved.
19
Ch apt er 2 Operation
Us in g th e B a l a n c ed A na l og O ut pu ts
2. Press the Next button several times until the Options Menu
appears..
Figure 2–6 Options Menu
3. Press either BNC or Fiber. This menu contains a variety of useful
options that can be used to customize the AMP1-MADIe to your
needs. Refer to Chapter 4 for details. Exit this menu by pressing
Next or pressing the Channel Volume knob for at least three
seconds.
Using the Balanced Analog Outputs
The AMP1-MADIe contains Left and Right channel outputs, as well as
a Mono Mix output. By default, these balanced analog outputs
produce line level signals and are unaffected by the Master Volume,
Balance, and Channel Volume controls. They output all unmuted
channels, as indicated by the bright blue icons in the middle of the
Main Screen.
Optionally, you can configure the system so that the Channel Volume
controls and/or the Master Volume and Balance controls will
control the balanced analog outputs. This configuration is useful if you
will be using external amplifiers and speakers. To do this, press the
Channel Volume button for at least three seconds until Audio Menu
1 appears (Figure 2–7 below).
Options Menu
NextBack
8 hrsScreen Saver
Press to select, then turn
Channel Volume to adjust.
MADI Input
Single-Mode Fiber Input
Coax Copper Input BNC
Fiber
Screen Bright
22 22
Left Right
ON Reclocking
Press and hold Channel Volume to exit menu.