User guide

82 10 1 6: AM Px- E8 Ser ie s U se r G u ide
© 2013 Wohl er Tec hn ologi e s , In c . Al l r ig h ts re se rved.
39
Ch apt er 3 Audio Configuration
Sett i ng t he Mo n ito r’ s S ta rt u p C on fi gu ra tio n
Setting the Monitor’s Startup
Configuration
You can configure the AMPx-E8 Series monitor to start up from a
powered-off state, and automatically begin monitoring a particular
input.
1. Press the Fn + Setup buttons.
2. Press the Down button until the LCD screens Startup
StartupStartup
Startup as shown
in Figure 3–13 below.
Figure 3–13 Startup Menu Option
3. Press the Enter button to display the Startup list.
4. Press the Up or Down buttons to scroll through the startup
options. Note that only those options that are available in your
system will show up in the list.
• Last Used
• Analog
• AES 1
• AES 2
• SDI 1
• SDI 2
• BSt1
• BSt2
• SDI 1 + DBY
• SDI 2 + DBY
5. Press the Enter button to make your selection and return to the
Setup Menu.
6. Press the Escape button to return to normal operation.
848131 3.03
Setup: Startup