User guide

82 10 1 6: AM Px- E8 Ser ie s U se r G u ide
© 2013 Wohl er Tec hn ologi e s , In c . Al l r ig h ts re se rved.
37
Ch apt er 3 Audio Configuration
SD I In pu ts
Press of the Group button to cycle through each of the eight choices in
the following order:
• G11/2
• G13/4
• G21/2
• G23/4
• G31/2
• G33/4
• G41/2
• G43/4
Configuring for SDI Delay
Modifying the SDI delay value allows you to precisely synchronize the
audio signal to a video signal.
To change the SDI Delay setting:
1. Hold the Fn button while pressing the Setup button.
2. Press the Down button until the LCD screens SDI Delay
SDI DelaySDI Delay
SDI Delay as
shown in Figure 3–11 below.
Figure 3–11 SDI Delay in the Setup Menu
3. Press the Enter button to select the option. The LCD display to an
image similar to that shown in Figure 3–12 below.
Example: G11/2 will appear on the bottom left hand side of the LCD screen when
the user wants to monitor a bitstream in the first sub-group of Group 1.
This corresponds to Channels 1 and 2 of an ordinary PCM embedded
audio signal. Similarly, G33/4 will appear when the user wants to
monitor a bitstream in the second sub-group of Group 3.
Important:
This function only works for SDI signal types.
848131 3.03
Setup: SDI Delay