User guide

821189: AMP1-16-M User Guide
© 2014 Wohler Technologies, I n c . A l l r ights reserve d .
65
Ap pe n di x D Upgrading the AMP1-16-M Using a USB Flash Drive
Upgrad ing the S oftwa re Us ing a USB F lash Dr ive
5. If you wish, you may use the View Versions button to display
the current versions in the unit against those on the flash drive, as
shown in the next figure.
Figure D–3 Software Update Versions Screen
6. From the Software Update Versions menu, press Return to
Last Menu to return to the Flash Drive Software menu shown
in Figure D-4 below.
Figure D–4 Flash Drive Software Update Screen
If the screen does not indicate that the software is up to date, you can
select one of two update options:
A. Press the Update Software as Needed button to install only
newer software versions contained in the flash drive into the
Software Update Versions
Return to
Last Menu
Application Ver :
Bootloader Ver :
Audio FPGA Ver :
Graphics FPGA Ver :
Current Versions :Update Versions
Application Ver :
Bootloader Ver :
Audio FPGA Ver :
Graphics FPGA Ver :
02.44
03.07
02.41
03.21
04.00
04.00
04.00
04.00
Flash Drive Software Update
Update Software
as Needed
Cancel / Quit
To exit without installing
software,
press Cancel /Quit
View Versions
Update only the outdated
parts of the software .
(Recommended )
Replace Software
Unconditionally
Update the software
regardless of version .
(Use cautiously )
The installed software
needs an update.