User guide

821189: AMP1-16-M User Guide

Appe nd i x B Using a Direct Connection

Us in g a D irect Con nection

Figure B–1 AMP1-16-M Manager

10. Once the unit appears, select it and complete any desired

operations as described elsewhere in this manual. If the unit fails

to appear after a few minutes, double check your connections and

the instructions above about disabling unused Ethernet ports.

11. When finished, be sure to disable the

Direct Mode

on the unit,

and return it to the previous Ethernet settings either through the

Windows GUI and the

Configure IP

function, or through the

Version and Ethernet Menu

as described previously.

12. Enable any network interfaces on the computer that were disabled,

and restore any settings that were changed.

13. Turn off the unit.

14. Shut down the computer.

15. Disconnect the computer from the unit.

Of course, if you are familiar with setting compatible static IP addresses

and subnets in both your host computer and the AMP1-16-M, that

option is open to you as well. You may use either an Ethernet patch

cable or a crossover cable for the connection.