User guide

ManualsBrandsWohler ManualsComputer equipmentAMP1-16-3G

821189: AMP1-16-M User Guide

Append ix A Connecting the A MP1-16-M to a LAN

Addi ng Your A MP1-16-M to Y ou r Ne two rk

5. When the

Enter AMP1-16-M IP Address

dialog displays, do

the following:

A. Click the

Use DHCP

check box (if needed) to select DHCP

B. Do NOT check

Direct Connect

if connecting to the unit

through a LAN. If you wish to connect to the unit directly,

see Appendix B on page 55.

C. Enter the

Unit IP address.

D. Enter the

Unit IP Mask

E. (Optional) Enter a Unit Name of up to 15 characters. The

name you select for this AMP1-16-M should denote its

position or function within your facility so that it can be easily

recognized later

F. Click

Update

to close the dialog. Click

Cancel

to ignore any

changes and return to the previous window. Note: A grayed

Update

button means the IP information is not correct.

To change the IP settings, the unit must restart. The Windows

application will automatically restart the unit, and display the unit

with its new address after it has rebooted. This takes

approximately 10 seconds.

6. Click

Refresh

. After the system polls the network, all the

AMP1-16-Ms on the network will display in the

Units

Responding

box.

7. If the unit is located on a different subnet than the host computer,

the Windows Manager may not be able to automatically locate it.

In this case, use the Locate IP button.

Important:

If your network uses DHCP, then skip Steps C and D and continue on

to Step E below.