User guide

821189: AMP1-16-M User Guide

Appe nd i x A Connecting the AMP1-16-M to a LAN

Ad di ng Your AM P1 -16-M to Y our N et wo rk

Adding Your AMP1-16-M to Your

Network

1. If you have not already done so, connect an Ethernet cable from

the Ethernet port of the AMP1-16-M (labeled

Ethernet

) to the

network.

2. Click

Refresh

3. Click on the unit you wish to configure in the

Units Responding

list.

4. Click

Config IP

Figure A–3 Enter AMP1-16-M Address Dialog

Note:

By default, the unit ships with DHCP addressing enabled. If

you wish to use DHCP mode, you may skip this section if

your unit appears in the

Units Responding

window.

Otherwise, you may configure the IP information using the

Version and Ethernet

menu inside the unit, or follow the

instructions below.

Note: The unit name may only be assigned using an

Ethernet connection.