User guide

821189: AMP1-16-M User Guide
© 2014 Wohler Technologie s , In c . A l l rights reserve d .
38
Chap ter 4 In te rnal Me nu Sy stem
Vers ion a nd Ethern et Me nu
Version and Ethernet Menu
This menu displays software and hardware versions, as well as
Ethernet settings. By default, the DHCP setting is enabled and the IP
Address and IP Mask settings are shown as 0.0.0.0. This means it will
automatically attempt to get the needed IP Address and IP Mask
settings from the network.
Figure 4–8 Versions and Ethernet Menu
• Factory Default : Pressing this button opens a cautionary window
to verify that you really want to restore the AMP1-16-M setup to the
factory default. If you press the Factory Default button again, the
action proceeds and the unit will restart. Otherwise, after five
seconds, the factory default request is cancelled. You can also cancel
the factory default request by pressing any other button.
• Set (IP Address or IP Mask) : Pressing this button highlights the
first of the four octets, turning the Menu/Trim encoder clockwise
increases the octet; turning it counterclockwise reduces the octet.
Pressing either the Set IP Address or the Menu/Trim encoder
advances the highlight to the next octet. Advancing beyond the last
octet returns the highlight to the first octet.
Version & Ethernet Menu
Back
Factory
Default
To quickly exit these Menus,
Unit Name:
<Not Set>
Application Ver: 02.27
NvRam Table Ver: 00.05
Bootloader Ver: 01.02
Audio FPGA Ver: 02.41
Graphics FPGA Ver: 03.01
Main PCA Ver: 02
Graphics PCA Ver: 02
Display Type: B
Finished
Ethernet IP Address
IP Address: 0
IP Mask: 0
0
0
0
0
0
0
Press Set to select the item;
turn the Trim control adjust.
DHCP mode enabled
press Trim for 3 seconds
Set
Addr Mode:
DHCP
Connect:
LAN
Note:
The Factory Default action restores the entire unit to
its factory condition. The unit name is deleted, the IP
Address is set to DHCP, and the Connect: setting is
reset to LAN.