User guide

821189: AMP1-16-M User Guide
© 2014 Wohler Technologie s , In c . A l l rights reserve d .
34
Chap ter 4 In te rnal Me nu Sy stem
Me te r Type and Refer en ce Me nu
turn the selected phase indicator On or Off . When set to On , an out
of phase condition for the associated pair will be displayed on the
Main Screen and when set to Off , out of phase conditions for the
associated pair will not be displayed on the Main Screen . By
default all phase indicators are enabled.
• Volume/Balance : Pressing this button causes the front panel
knobs to function as Volume and Balance controls. This is the
default setting.
• Left/Right Volume : Pressing this button causes the front panel
knobs to function as Left Volume and Right Volume controls.
Meter Type and Reference Menu
The Meter Type and Reference Menu allow you to define the level
meter scale, float, bar and reference.
Figure 4–6 Meter Type and Reference Menu
• Scale : Pressing this button and then rotating the Trim knob steps
through the scales for the level meters. Six selections are available as
shown in Table 4–1 below.
Meter Type & Reference Menu
Back Next
AES
Single
Scale
Float
0
-60
-50
-40
-30
-10
-20
VUBar
Mono Chan .
Select
Multiple
Audio Pair
Select
0 dBr = 0 dBFS Reference
To quickly exit these Menus Press TRIM for 3 seconds .
Press any key to select , and
turn the Trim control to adjust .
Single
DisableEnable
Table 4–1 Meter Limits and References
Scale
Bottom
Limit
Top Limit
Default
Reference
Default Color
Bounds
Default Ballistics
Lower Upper Float Bar
AES -72 dBFS 0.0 dBFS 0 dBFS = 0 dBFS -30 dBFS -20 dBFS
IEC
Type I
VU
VU -45 dBr +3.5 dBr -20 dBFS = 0 dBr -3 dBr 0 dBr — VU