User guide

821189: AMP1-16-M User Guide
© 2014 Wohler Technologie s , In c . A l l rights reserve d .
32
Chap ter 4 In te rnal Me nu Sy stem
Op ti on s M enu
• Channel goes to Left Output only : Pressing this button sets the
selected channel to go to the left speaker and to the left analog
output.
• Channel goes to Right Output only : Pressing this button sets
the selected channel to go to the right speaker and to the right
analog output.
Options Menu
The Options Menu allows you to adjust the brightness of each screen
independently, and to set the duration of inactivity before the screen
saver activates.
Figure 4–5 Options Menu
• Screen Bright : Press this control to toggle between the
adjustment for the left screen and the right screen. When a screen is
selected, rotate the Menu knob to adjust the screen brightness.
Thirty-two adjustment steps are provided for each screen from very
dim to bright. The actual brightness of each screen will change as
the control is turned. The default brightness for both screens is 22.
• Screen Saver : Pressing this button and then rotating the Menu
knob selects the screen saver timeout. Select values from 5 minutes
to 119 minutes (in 1-minute increments) and from 2 hours to 24
hours (in 1-hour increments). The default setting is 8 hours.
If the AMP1-16-M is in operation for the screen saver timeout
period and no front panel controls have been turned or pressed, the
screens will dim by a certain amount. If double the screen saver
Options Menu
Screen Bright
Back
22 22
Left Right
8 hrs
Screen Saver
Enabled
Audio Muting
& Delay
Press to select, then turn the
Trim control to adjust .
PA HeaderNon-Audio
Enabled
Delay
4 ms
To quickly exit these Menus,
Minimum
Recommended
Delay = 42 ms
Select
Volume /
Balance
Left/Right
Volume
Next
2 3 4 5 6 7 8
Press Select and turn the
Trim control to select a
pair-wise phase indicator.
Press the Trim control to
determine whether
indicator will appear on the
meter screen.
Phase Indicators
1
press Trim for 3 seconds