User guide

821189: AMP1-16-M User Guide
© 2014 Wohler Technologies, I n c . A l l r ights reserve d .
31
Ch apter 4 Internal Menu System
Ch annel A ssign me nt Menu
2. Trim Mode: Pressing this button puts the product in Trim mode
and automatically selects Enabled for the Enabled/Disabled
button. The Trim Screen can be accessed when the Trim control
is pressed but any Trim adjustments only affect the speaker and
headphone volume when the Trim Screen is showing.
3. Dual Mode: Pressing this button puts the product in Dual mode
and automatically selects Enabled for the Enabled/Disabled
button. The Trim Screen can be accessed when the Trim control
is pressed and any Trim adjustments always affect the speaker
and headphone volume, whether the Trim Screen or the Main
Screen are showing.
4. Reset Trim Levels : Pressing this button opens the following
warning screen in place of the right-hand display: “Reset all trim
gains or losses for both SDI inputs to zero. Press again to confirm.”
Pressing this button again resets all of the Trim gains to zero for
both SDI inputs.
Channel Assignment Menu
This menu allows setup of channel-to-speaker assignments.
Figure 4–4 Channel Assignment Menu
Turning the Trim knob left or right highlights each of the 16 channels.
Rotate to select a channel, then press Both , Left , or Right .
• Channel goes to Both Outputs : Pressing this button sets the
selected channel to go to both speakers and both analog outputs.
Channel goes to Left Output only Channel goes to Right Output only
Channel goes to Both Outputs
Turn the Trim control to move the yellow
highlight to the channel to be configured .
NextBack
Left /
Right
Center
LFE
L/ R
Surrnd
Bit
Stream
Pair
4
Pair
6
Pair
7
123456
123456
421 65 87 1211 1413 1615
To quickly exit these Menus , press Trim for 3 seconds
3 109