User guide

821189: AMP1-16-M User Guide
© 2014 Wohler Technologie s , In c . A l l rights reserve d .
24
Chap ter 3 AM P1 -16 -M G rap hi ca l U ser Int er fa ce (G UI) Man ager
Th e USB Tab
To perform any of the following functions, you must have an
AMP1-16-M selected in the Units Responding box.
• Get from Unit : Clicking the Get from Unit button transmits the
configuration file from the AMP1-16-M that you selected on the
Units Responding box to the PC.
• Save : Clicking the Save button allows you save an AMP1-16-M
configuration file to the PC.
• Open : Clicking the Open button allows you to select an
AMP1-16-M configuration from those saved on your PC.
• Send to Unit : Clicking the Send to Unit button allows you to
transfer an AMP1-16-M configuration file from your PC to the
AMP1-16-M that is selected in the Units Responding box.
• Disconnect from Remote Unit: Click this button to disconnect
from the remote unit. The front-panel USB functions and menu
system will be unlocked.
The USB Tab
You can copy up to seven configuration files to or from a USB flash
drive connected to your computer. You can then use this USB flash
drive to copy those settings into an AMP1-16-M using the front-panel
USB connector.
When one or more flash drives are connected to the computer, they will
be shown in the Drive list box, and any settings files found on the
selected rive will be shown in the Flash Drive Files window.
Note:
The button descriptions below are not listed in the order that
they appear on the Ethernet tab. Instead, they are listed in
the most likely order that you would use them.
Note:
To use the USB port from the AMP1-16-M menu system,
refer to USB Port Functionality on page 14.