User guide

821189: AMP1-16-M User Guide
© 2014 Wohler Technologie s , In c . A l l rights reserve d .
20
Chap ter 3 AM P1 -16 -M G rap hi ca l U ser Int er fa ce (G UI) Man ager
Th e Op tions Tab
you can click the Meter Scale Default button to return to the
default for that scale. The scale itself won't change.
3. Also in the Level Meters area, click the up or down arrows to
select the levels at which the colors between the top and middle
segments and the middle and lower segments.
4. Click the up or down arrows to select the colors for each of the
level meter segments.
5. In the Speaker Mute area, click to select one of three speaker
configurations:
A. Never : Never mute the speakers even when headphones are
connected.
B. Phones : Only mute the speakers when the headphones are
connected.
C. Always : Always keep the speakers muted. This option may
be useful if you only want to monitor audio externally,
through the XLR audio outputs on the rear panel.
6. In the Analog Output area, click to select one of three output
volume options. Fixed Line Level is exclusive of the other two:
A. Fixed Line Level : The volume of the output is fixed to the
volume of the corresponding inputs.
B. Volume/Balanced Controlled : The volume of the outputs
is controlled by the Volume and Balance knobs on the front
panel.
C. Trim Controlled : The analog outputs are controlled by the
Trim settings.
7. In the Audio Muting and Delay area select any combination of
Non-Audio or PA Header .
Note:
Note, if the Analog Output is set to controlled and the
Speaker Mute is set to Always , then plugging in the
headphones will cause the analog outputs to mute.
Note:
The AMP1-16-M detects PA headers that represent
encoded data streams.