User guide

821189: AMP1-16-M User Guide
© 2014 Wohler Technologies, I n c . A l l r ights reserve d .
15
Chap ter 2 Operation
US B P or t Functio na lity
Copying a Configuration From the AMP1-16-M
1. To load a configuration file to the AMP1-16-M from your flash
drive, press Get . The Get a setup from the Flash Drive screen
will display as shown in Figure 2–6 below.
Figure 2–6 Get a Setup From the Flash Drive Screen
2. Using one of the bright green choices, press the file number (File 1
through File 7)of the file you want to copy from your flash drive.
Once the copy process completes, the Flash Drive Connected
screen re-displays.
3. Remove the flash drive from the USB port.
Copying a Configuration File from the AMP1-16-M
1. To copy a file to the flash drive from the AMP1-16-M, press Save
from the Flash Drive Connected screen. The Save to Flash
Drive screen will display as shown in Figure 2–7. The lighter color
buttons indicate file numbers that are already occupied with data.
Get a setup from the Flash Drive
File 5
File 6
File 7
File 1
File 2
CancelFile 4
File 3
Select the Flash
Drive file number
1 to 7 from which
to get a new
AMP 1-16M
configuration
To exit without making
any changes , press
Cancel .
Note:
The configuration takes effect immediately when you
press the File button.