User guide

821189: AMP1-16-M User Guide
© 2014 Wohler Technologie s , In c . A l l rights reserve d .
14
Chap ter 2 Op erat i on
USB Po rt Fu nc tiona lity
USB Port Functionality
You can copy configuration files to and from your unit by using a flash
drive connected to the USB port. You can also use a flash drive to
update the software in the AMP1-16-M. Refer to Appendix D on page
63 for instructions. Configurations may also be created in the PC GUI,
and transferred to a USB flash drive which can then be inserted into the
unit. Appendix D on page 63.
Immediately after connecting the flash drive to your AMP1-16-M, the
Flash Drive Connected screen displays (interrupting any current
functions except an Ethernet connection) as shown in Figure 2-5: below.
The menu flow for the USB menu set is shown immediately below in
Figure 2-4. The Update Menu button will only appear if the USB drive
has had programming files added to it. Again, refer to Appendix D.
Figure 2–4 Flash Drive Configurations Screen
Figure 2–5 Flash Drive Connected Screen
Flash Drive Connected
Get1
Save2
3
4
5
6
Update Menu
7
8
Flash Drive Insertion
Save to Flash Drive
File 11
File 22
File 33
File 44
File 7
5
File 6 6
File 5
7
Cancel/Quit 8
Get from Flash Drive
File 11
File 22
File 33
File 44
File 7
5
File 6 6
File 5
7
Cancel/Quit 8
Flash Drive Software Update
Update1
2
3
View Ver4
5
6
Replace
7
Cancel/Quit 8
Flash Drive Connected
Get System Config . from
Flash Drive
Save System Config . to
Flash Drive
To exit this menu ,
remove the USB device
Get
Save
Update the unit software
from the flash drive .
Update
Menu
Note:
All configuration files end in the .wcfg extension.