User guide

821189: AMP1-16-M User Guide
© 2014 Wohler Technolog ies, I n c . A ll r i g h t s reserved
7
Chap ter 1 Quick Start
Re ar P anel
Rear Panel
Figure 1–2 Rear Panel Layout
• Power: The AMP1-16-M uses a standard IEC power cord for the 100
to 240 VAC ±10%, 50/60 Hz power connection.
• 3G/HD/SD-SDI Inputs: These two BNC connectors accept the
3G/HD/SD-SDI input signals.
• 3G/HD/SD-SDI Outputs: These BNC connectors output
regenerated replicas of the two 3G/HD/SD-SDI input signals.
• Selected 3G/HD/SD-SDI Re-Clocked Output: This BNC connector
re-clocks the selected 3G/HD/SD-SDI input signal.
• Ethernet: The Ethernet port can connect to either a LAN or a PC to
let you customize the AMP1-16-M configuration. It will also allow
you to copy configurations from one AMP1-16-M to another. Lastly,
it can be used to update the AMP1-16-M software and firmware.
Refer to Chapter 3, Appendix A, Appendix B and Appendix C for
details.
• Analog Outputs: These XLR connectors provide two channels of
balanced analog outputs. The source of these signals is the mix of
audio monitored by the internal speakers.
Power
Ethernet
3G/HD/SD-SDI 1 and 2
(Inputs and Outputs)
Analog Audio Outputs
(Left & Right)
Selected SDI