User guide

821189: AMP1-16-M User Guide

Chap ter 1 Quic k Start

Comp lia nc e

materials between adjacent vibrating surfaces, or tying up loose cables,

etc., may be required to stop vibrations external to the unit.

Mechanical Bracing

The 1RU chassis is securely attached to the front panel. In addition, the

chassis has mounting tabs through which you attach it to the rack rail.

This feature will reduce or eliminate rear bracing requirements in many

mobile/portable applications. The weight of internal components is

distributed fairly evenly around the unit.

Electrical Interference

Be careful to avoid mismatched cable types and other similar causes of

undesired reflections in digital signal systems. If severe enough, such

reflections can result in corruption of the digital data stream. As with

any audio equipment, maximum immunity from electrical interference

requires the use of shielded cable; however, satisfactory results can

sometimes be obtained without it. The internal circuitry ground is

connected to the chassis.

Power

The unit comes with a standard internal power supply and connects an

A/C mains power source (60W, 100 to 240 VAC, ±10%, 50/60Hz)

through the IEC connector provided on the rear panel of the unit.

When the mains plug or appliance coupler is used as the disconnect

device, the disconnect device should remain operable.

Compliance

FCC

This equipment has been tested and found to comply with the limits for

a Class A digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio